A Charging Handle for the 21st Century Gun Fighter
A NEW Charging Handle and Extended Latch System
Charging Handle Machined from 7075 T6 Billet
Hard Coat Anodized per Mil-A-8625F, Type III, Class 2
GFH - Mod3 (large latch), Mod4 (medium latch) and Mod5 (small latch)
order to perform an immediate action or charge the carbine, current CQB
techniques have the operator racking the charging handle to the rear
using their support side hand only. This is done in one swift and strong movement. With
the operators firing grip maintained, the weapon again has a loaded
chamber, and the shooter can immediately bring a hot weapon back into
and forceful support hand only racking of the charging handle
eventually can lead to breaking the roll pin and loosing the latch
the latch blown out, the charging handle will not stay secured to the
receiver as the bolt is moving back and forth during each cycle of the
weapons action. Not a good situation on a two way range.
BCMGUNFIGHTER Charging Handle and extended latches feature internal
redesigns to direct the force off of the roll pin and into the body of
the charging handle during support hand only manipulations. This new design has a built in backstop engineered into the extended latch and into the charging handle. As the latch is opened up, its travel is limited by these flat surface backstops. With
this travel limiting feature, the stress is taken off the roll pin, and
is now redirected into the entire body of the charging handle.
Sorry no APO on this item.